Icom ic-7800 sn
- #ICOM IC 7800 SN SERIAL NUMBER#
- #ICOM IC 7800 SN INSTALL#
- #ICOM IC 7800 SN UPGRADE#
- #ICOM IC 7800 SN FULL#
2.0 is displayed at the lower right corner of the display when the radio is first switched on during the boot up sequence if it has the 3kHz roofing upgrade.Īll screen shots are simulated pictures.
#ICOM IC 7800 SN UPGRADE#
Important Upgrade Note: Icom has produced an important upgrade for the IC-7800. And Icom really stands behind this radio with a limited two year factory warranty. The high resolution 7 inch TFT color LCD display provides more operating information than you've ever had before, including a spectrum scope. This radio covers the HF ham bands plus 6 meters (receive from 30 kHz - 60 MHz). The supplied accessories include: rack mounting ears, compact flash and various plugs (mic not supplied). A 120 VAC switching power supply is built-in.
#ICOM IC 7800 SN FULL#
The newly designed push-pull MOSFET amplifiers work with a 48 VDC, providing a powerful 200 watts of output at full duty cycle with low IMD in all bands. And nothing is sacrificed on the transmit side. The rear panel features four primary antenna inputs plus provisions for receive antenna A and B. There is even a separate preamp and mixer for the 6 meter band. And you enjoy this incredible performance in two fully independent receiver circuits controlled on the left side of the radio. By sparing no expense an incredible +40dBm intercept point has been achieved with ultra wide dynamic range. As impressive as the features are it is performance that sets this radio apart. It utilizes four separate 32-bit floating point DSP chips, has a 7-inch wide TFT display, built in RTTY/PSK31 receive and transmit plus compact flash technology. The Icom IC-7800 is clearly one the most advanced amateur radio ever developed. MFJ-870 SWR meter, 1.Icom IC-7800 Amateur Transceiver, Icom 7800įeatures | Specifications | Accessories | Rear Panel | Larger Image.Supported Modes: All mode AM, FM, SSB, RTTY, CW.This item can be shipped to United States. The seller is “ac7av_on_whidbey_island” and is located in Greenacres, Washington. This item is in the category “Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Transceivers”. The item “Icom IC-7000 HF VHF UHF All Mode Mobile Radio Transceiver” is in sale since Tuesday, May 4, 2021. This radio has just been sitting in the closet. The RJ-13D cable was used with my other Icom IC-7000 when I had it hooked up using an ALS600S amplifier.
#ICOM IC 7800 SN INSTALL#
I have a second IC-7000 radio and this was just a backup that I was going to install in my wifes Jeep wrangler, but we went with a different setup. It was never hooked up as a primary radio since Ive had it. I bought it years ago and have only verified it operates TX and RX correctly and its basic function. SN#0507533 This specific radio has not had much use.
#ICOM IC 7800 SN SERIAL NUMBER#
The serial number is above the point of the early version that had an overheating problem. Sorry, no original box but will be very well packaged. And I put a MIX-31 toroid on the cable for RFI mitigation. I modified it and brought out connectors for other functions for computer audio interfacing and other external relay switching functions, or direct amplifier operation without the ARI-500. The RJ-13D is a modified cable, the stock RJ-13D cable only has the ARI-500 RJ45 connector and ALC out. RJ-13D 13 pin DIN cable, ARI-500 interface, ALC, Audio In, Audio Out, and amp buffer relay. Also included is the OPC-1443 remote separation cable. This radio comes with original, HM151 microphone, Power cable with ring connectors, Owners Manual. Here is a very nice example of an Icom IC7000. Icom IC-7000 transceiver HF, VHF, UHF, Ham shack in a box. Icom IC-7000 HF VHF UHF All Mode Mobile Radio Transceiver.